crwdns2933803:03crwdne2933803:0
crwdns2933797:0ilyas404crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 ilyas404
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Use a [guide|750|soldering iron|new_window=true] to desolder the points where the trigger assembly is attached to the motor assembly. |
|---|---|
| - | [* icon_caution] The soldering iron is very hot and will burn. Use with caution. |
| + | [* black] Step 3: Find and replace the Previous Trigger Where is the trigger assembly, it should be found somewhere inside the drill. |
| + | [* black] It’s the component affixed to the motor and the wires. Loosen the wiring of the trigger carefully in such a way that you have to separate the connections on the terminals. |
| + | [* icon_note] Tip: Remove the wires, then take a picture so that you can remember how they should be connected. Pull the old trigger out from its engagement with the housing. |
| + | [* black] Ilyas. |