crwdns2894164:0crwdne2894164:0

crwdns2890822:0crwdne2890822:0

crwdns2890844:0crwdne2890844:0

crwdns2861143:0crwdne2861143:0

crwdns2892164:02crwdne2892164:0

crwdns2892146:0Timothy Protocrwdnd2892146:0crwdne2892146:0

crwdns2875918:0crwdne2875918:0 crwdns2892120:0crwdne2892120:0 Timothy Proto

crwdns2892174:0crwdne2892174:0
crwdns2892176:0crwdne2892176:0
crwdns2892148:0crwdne2892148:0

crwdns2892168:0crwdne2892168:0

[* black] After removing the ribbon cables, take note of the screws holding the motherboard into the main chassis of the camera.
[* red] There are two types of screws to remove. The four (2mm, PH00) circled in red have a fat head, and go in the gold contact.
[* greenorange] The three (4mm, PH00) screws marked in green have a skinny head.
[* greenorange] The three (4mm, PH00) screws marked in green have a skinny head.
[* black] Use the IFIXIT screwdriver and PH0 bit to remove all the screws holding the motherboard.

crwdns2892134:01crwdne2892134:0

crwdns2892140:0crwdne2892140:0

crwdns2892144:0crwdne2892144:0