crwdns2933803:04crwdne2933803:0
crwdns2933797:0Chris Benedictcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Chris Benedict
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Locate a third ribbon cable on the underside of the motherboard, as shown in the picture (observe the battery hatch for proper orientation). |
|---|---|
| - | [* black] Remove the cable from its connector, following the same process as the two connectors before it. |
| - | [* black] Once the three cables are removed, the motherboard will rotate about the far edge. |
| - | [* icon_caution] The motherboard is not yet completely detached at this point. Be sure to rotate it carefully so that the remaining connections are not damaged. |
| + | [* black] Locate a third ribbon cable on the underside of the motherboard (near the battery hatch). |
| + | [* black] Remove the cable from its connector, following the same procedure as above. |
| + | [* black] Once these three ribbon cables have been removed, the motherboard will be connected to the case only by a fourth ribbon cable and a pair of red and black wires in one corner. |