crwdns2933423:0crwdne2933423:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Ben Eisenmancrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable.
+[* black] Use a small iPod opening tool to release the black hinge holding the hard drive ribbon cable. The tab will rotate up 90 degrees towards the logic board, releasing the ribbon cable.
[* black] Use your forefinger to hold the ribbon cable in place; disconnect the drive from the ribbon cable.
[* icon_note] Make sure the hard drive rubber side bumpers are attached to the drive being installed. Use the hard drive rubber side bumper installation guide to accomplish this task.
[* icon_note] If necessary, the blue foam padding on the hard drive might also need to be transferred to the replacement drive.