crwdns2933803:01crwdne2933803:0
crwdns2933797:0Cameron Justcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Cameron Just
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Take out the four 3.5 mm diameter (measured from thread), 15 mm long screws with the PH1 and T10 Screwdriver head using the black, rubber torque assistance tool. |
|---|---|
| + | [* black] Take out the four 3.5 mm diameter (measured from thread), 15 mm long screws with the PH1 and T10 Screwdriver head using the black, rubber torque assistance tool. Twist counter-clockwise to remove screws. |
| [* black] One screw is a lock screw where you will use the T10 head, the other three are PH1. According to this picture, the lock screw is located in the bottom right. | |
| [* black] Place the 4 screws on the magnetic mat. |