crwdns2933803:01crwdne2933803:0
crwdns2933797:0jakebontragersingercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 jakebontragersinger
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* icon_caution] Before beginning, make sure the motor direction switch is in the neutral position. |
|---|---|
| + | [* red] Place the drill on the work surface with the chuck facing downward. Locate and remove the two #1 X 10mm Phillips screws located right of the motor. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0