crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Andrew Bookholtcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Insert a 1.2 mm Phillips screw into each of the outer holes drilled into the trackpad (two screws total).
[* icon_caution] You'll install the rest in a bit.
-[* icon_note] When you tighten the two screws, make them tight and then back them out about a quarter turn to aid in aligning your trackpad during the next few steps.
+[* icon_note] Tighten the screws, then back them out about a quarter turn to aid in aligning your trackpad during the next few steps.