crwdns2933423:0crwdne2933423:0

crwdns2933803:07crwdne2933803:0

crwdns2933797:0David Spaldingcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 David Spalding

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[title] Reinstall the glove box stops and retaining arm
+[* black] Reinstall the left and right glove box stops just as they were removed. Close the glove box so that when the stops are reinserted into the holes, the rubber bumpers are above the dashboard fascia. Slide the stops upwards in the holes so that the tabs on the flanges snap into the glove box holes.
+[* icon_note] The flanges should rest flat against the inside wall of the glove box. If they do not rest flat, you have not pushed the stops up all the way in the holes.
+[* black] Lift the glove box closed and very slowly pull the pneumatic arm down to the notch in the glove box door. From the rear of the notch (towards the engine), snap the "C" clasp back on to the pin in the notch.
+[* black] Put your belongings back into glove box and close. You're done!