crwdns2933803:01crwdne2933803:0
crwdns2933797:0Patty Remmellcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Patty Remmell
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Start by removing the housing cap by unscrewing it. | |
| [* red] Next, unscrew the now exposed collet nut while holding down the shaft lock button. The arrow shows the location of the shaft lock button. | |
| [* icon_note] To remove the collet nut, you may need to use the small open-end wrench provided with the Dremel. | |
| - | [* black] Remove the metal |
| + | [* black] Remove the metal hanger by pulling prongs out from the casing. |