crwdns2933803:01crwdne2933803:0
crwdns2933797:0John Cobbcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 John Cobb
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Start by unscrewing the housing cap. |
|---|---|
| - | [* red] Then, unscrew the now exposed collet nut while holding down the shaft lock button. |
| + | [* black] Start by removing the housing cap by unscrewing it. |
| + | [* red] Next, unscrew the now exposed collet nut while holding down the shaft lock button. The arrow shows the location of the shaft lock button. |
| + | [* icon_note] To remove the collet nut, you may need to use the small open-end wrench provided with the Dremel. |
| [* black] Remove the metal hangar by pulling prongs out from the casing. |