crwdns2933803:09crwdne2933803:0
crwdns2933797:0Richard Stidstoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Richard Stidston
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] AliTech Shifter Chassis | |
| [* icon_note] Note: To aid installation, we recommend removing the the shifter assembley from the shifter chassis. | |
| [* black] Trial fit the shifter chassis to the front and rear mounts. Whilest doing this, be sure to feed the shifter and handbrake cable through the shifter chassis assembley. | |
| - | [* |
| + | [* black] Once in situ, check that the front of the shifter sits flush over the front mounting bracket. If misaligned, insert washers beneath the mounting bracket so that the shifter chassis fits flush (no gaps) |
| [* black] Remove the cable block from the shifter chassis. | |
| [* black] Feed the shifter cables through the shifter block, securing them in place using the dowel pins supplied. | |
| [* icon_note] Note: The cable block is handed. The holes should be nearest to the right hand side of the shifter assembly - this is to give clearance for the handbrake assembly and cable. | |
| + | [* black] With the cables attached, install the shifter chassis to the front mounting bracket. The wiring loom should be fed inside the shifter. |