crwdns2933803:05crwdne2933803:0
crwdns2933797:0Richard Stidstoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Richard Stidston
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Shifter & Handbrake Cables | |
| [* black] Detach the cable from the bottom of the handbrake. | |
| [* icon_note] Note: This can be made easier by removing the entire handbrake from the shifter unit. | |
| [* black] You will need to remove the handbrake microswitch from the shifter. This will be fitted in a similar position on the AliTech shifter in Step 10. | |
| - | [* icon_caution] Make sure the gearbox |
| + | [* icon_caution] Make sure the gearbox is in neutral before carrying out the following steps. This will aid in setting up the AliTech Shifter. |
| [* black] Remove the remaining bolts securing the front of the shifter to the car chassis | |
| [* black] Undo the block holding the shifter cables in place. This is held with 4 screws - two either side. | |
| [* black] Unfasten the two rod ends from the shifter mechanism. | |
| - | [* icon_note] Note: if the rod ends are riveted to the shifter mechanism you will need to unfasten them from the ends of the shifter cable. |
| + | [* icon_note] Note: if the rod ends are riveted to the shifter mechanism you will need to unfasten them from the ends of the shifter cable. The two supplied rod ends will be used in their place. |