crwdns2933803:05crwdne2933803:0
crwdns2933797:0Richard Stidstoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Richard Stidston
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Shifter & Handbrake Cables | |
| [* black] Detach the cable from the bottom of the handbrake. | |
| [* icon_note] Note: This can be made easier by removing the entire handbrake from the shifter unit. | |
| [* black] You will need to remove the handbrake microswitch from the shifter. This will be fitted in a similar position on the AliTech shifter in Step 10. | |
| + | [* icon_caution] Make sure the gearbox it in neutral before carrying out the following so as to aid in setting up the AliTech Shifter. |
| [* black] Remove the remaining bolts securing the front of the shifter to the car chassis | |
| [* black] Undo the block holding the shifter cables in place. This is held with 4 screws - two either side. | |
| [* black] Unfasten the two rod ends from the shifter mechanism. | |
| [* icon_note] Note: if the rod ends are riveted to the shifter mechanism you will need to unfasten them from the ends of the shifter cable. |