crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:011crwdne2933803:0

crwdns2933797:0gibby420crwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Remove the following 8 screws:
- [* red] Five 2.3 mm Phillips #00 screws with partial threads securing the logic board to the rear panel.
- [* orange] Two 2.3 mm Phillips #00 screws with full threads securing the logic board and camera.
+ [* red] Five 2.3 mm Phillips #00 screws with partial threads securing the shaft to the balls.
+ [* orange] Two 2.3 mm Phillips #00 screws with full threads securing the shaft and mushroom-head.
[* yellow] One 2.9 mm Phillips #00 screw from beneath the "Do not remove" sticker.
[* black] Note for re-assembly:
- [* black] The screw that goes next to the camera (bottom right orange highlighted screw) also has a metal strip that holds the camera in place.
- [* black] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the camera
+ [* black] The screw that goes next to the mushroom-head (bottom right orange highlighted screw) also has a metal strip that holds the mushroom-head in place.
+ [* black] Remember to put this strip back in place before you insert the 2.3 mm Phillips #00 screws with full thread next to the mushroom-head.