crwdns2933803:01crwdne2933803:0
crwdns2933797:0Ron Daviscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ron Davis
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Begin by using a heat gun or the iOpener ( |
|---|---|
| + | [* black] Begin by using a heat gun or the iOpener (This will take longer.) to melt the adhesive all around the outer edge of the screen. |
| [* icon_caution] Avoid holding the heat gun too close to the Microsoft Surface 2 so as to not cause any unwanted warping. | |
| - | [* icon_caution] Avoid touching the metal end of the gun |
| + | [* icon_caution] Avoid touching the metal end of the gun. It will be very hot and can burn you. |
| [* black] Insert the opening picks just under the screen and black edging. Be sure to place them evenly on each side. | |
| - | [* black] Using the gap created |
| + | [* black] Using the gap created by the picks, slowly pry the screen from the body of the Microsoft Surface 2 with a plastic opening tool. Pry as uniformly as possible. |