crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Briancrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Next step will be to make the edge connector out of a scrap piece of PCB.
-[* black] I chose a scetion of ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'. This one pictured had a via in exactly the wrong place and it had to be drilled out.
+[* black] I chose a section with ground plane on at least one side. It was sanded down to fit and scored to make 4 'traces'.