crwdns2933805:0crwdne2933805:0
crwdns2933797:0Nick Mathescrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick Mathes
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Connect new motor to chuck by pushing pieces together. |
|---|---|
| + | [* black] Reconnect the red and black wires to the motor. |
| + | [* black] Place motor and trigger assembly into the drill case. Push the battery tab back in. |
| + | [* black] Place the half of the drill that was aside back on top of the half with the motor. Push together until off sides are flush together. |
| + | [* black] Insert the eight screws into the drill housing. Tighten using the T8 Torx driver. |
| + | [* black] Using the angled pliers, insert the clip that was removed in step 2. Make sure the clip is seated in the slot properly. |
| + | [* black] Insert battery and pull trigger to test function. |