crwdns2933805:0crwdne2933805:0
crwdns2933797:0Devin Poulincrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Devin Poulin
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Remove 3/4 screws as shown with a PH1 screwdriver. One screw acts as the "lock", this one must be unscrewed with a T10 screwdriver. |
|---|---|
| + | [* black] Take out the 4 3.5 mm diameter (measured from thread), 15 mm long screws with the PH1 and T10 screwdriver head using the black, rubber torque assistance tool. |
| + | [* black] One screw is a lock screw where you will use the T10 head, the other three are PH1. According to this picture, the lock screw is located in the bottom right. |