crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Andrew Optimus Goldheartcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Andrew Optimus Goldheart

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Remove the following six screws securing the logic board assembly to the upper case.
[* red] One 3.8 mm T5 Torx screw
[* orange] Two 5.7 mm T5 Torx screws
[* yellow] One 5.6 mm T5 Torx screw (this one is silver and has a taller head than the others)
[* green] One 2.6 mm T5 Torx screw
[* light_blue] One 3.2 mm T5 Torx screw
-[* icon_note] On reassembly, start all six screws but do not tighten any of them. Move the logic board around until all of the screws are centered in their holes, and the ports are lined up with their openings in the side of the upper case. Then tighten all of the screws.
+[* icon_reminder] On reassembly, start all six screws but do not tighten any of them. Move the logic board around until all of the screws are centered in their holes, and the ports are lined up with their openings in the side of the upper case. Then tighten all of the screws.