crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Keegan Williamscrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Keegan Williams

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Use PH00 Phillips head from the iFixit Tool Kit to remove 3 screws from the circuit on the back half of the device.
[* black] Flip over the larger circuit board to the left.
[* icon_note] Use the edge of the circuit board to flip the board over.
-[* icon_caution] The top right corner might be harder, use the corner to disconnect it. Make sure the circuit board is over the screw port from the connector port, in order to lift the corner up.
+[* icon_caution] The connector port in the top right corner may make removal difficult. Lift the logic board above the screw ports, and the connector port should slide out easily.