crwdns2933803:04crwdne2933803:0
crwdns2933797:0Antti Immonencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Antti Immonen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing the shield of the SIM reader |
|---|---|
| + | [* black] draft: add kapton/aluminum foil using an iron or a heatgun, start undoing the sim-reader shield's attachment points from logic board gently pry up with tweezers or screwdriver and hold the shield up after it pops out of each attachment point. |
| + | [* black] release after solder has solidified go around the shield, being careful to not pry too hard until solder has melted, otherwise you will pull pads. |
| + | [* icon_caution] It can be annoying to glue the shield back if too many pads are missing, however, none of them is crucial to the functioning of the SIM reader |