crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Lee Scrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Lee S

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* blue] Loosen the ribbon cables from the board.
- [* blue] 1-Directly below the viewfinder.
- [* blue] 2-At the Base of the board.
- [* green] 3-At the top right near the selector wheel. 1 on top of the board 2 on the underside.
- [* yellow] 1-The center of the board, above the central hole.
-[* red] With metal tweezers, remove the two white plastic clips from their sockets one on the base of the board and the other on the surface.
-[* icon_note] The bullets apply to the three pictures on the step.
+[* blue] Gently separate the seven ribbon cables from the motherboard.
+ [* blue] There is one directly ***below the viewfinder*** (Image 1, blue).
+ [* blue] Two are on*** the base of the camera ***(Image 2, blue).
+ [* green] There are three at ***the top right of the motherboard, near the selector wheel***. One is on the top of the board, and two are on the underside (Image 1, green).
+ [* yellow] The final one is in ***the center of the board, near the central hole*** (Image 1, yellow).
+[* red] Remove the two white plastic clips from their sockets with metal tweezers. One is on the ***base of the board*** (Image 2, red) and the other is on the surface (Image 1, red).
+[* icon_note] The bullets apply to all three picture included with this step.