crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Lee Scrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Lee S

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* blue] Loosen the ribbon cables from the board.
- [* blue] 1-Directly below the viewfinder.
- [* blue] 2-At the Base of the board.
- [* green] 3-At the top right near the selector wheel. 1 on top of the board 2 on the underside.
- [* yellow] 1-The center of the board, above the central hole.
-[* red] With metal tweezers, remove the two white plastic clips from their sockets one on the base of the board and the other on the surface.
-[* icon_note] The bullets apply to the three pictures on the step.
+[* blue] Gently separate the seven ribbon cables from the motherboard.
+ [* blue] There is one directly below the viewfinder (Image 1, blue).
+ [* blue] Two are on the base of the camera (Image 2, blue).
+ [* green] There are three at the top right of the motherboard, near the selector wheel. One is on the top of the board, and two are on the underside (Image 1, green).
+ [* yellow] The final one is in the center of the board, near the central hole (Image 1, yellow).
+[* red] Remove the two white plastic clips from their sockets with metal tweezers. One is on the base of the board (Image 2, red) and the other is on the surface (Image 1, red).
+[* icon_note] The bullets apply to all three picture included with this step.