crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Spencer Craigiecrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Craigie

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Peel the black tape off of the back surface of the LCD
-[* red] Remove the four 3 mm screws on the LCD bracket.
-[* orange] Remove the two 2 mm screws from the top of the bracket.
-[* black] Lastly, using a spudger, pop the LCD out of the camera back plate.
-[* icon_note] When the bracket comes off, be aware that the buttons from the top section will fall out of place if the plate is inverted.
+[* black] Peel the black tape off the back of the LCD.
+[* red] Remove the four 3mm screws on the LCD bracket.
+[* orange] Remove the two 2mm screws from the top of the bracket.
+[* black] Use a spudger to pop the LCD screen out of the camera’s backplate.
+[* icon_note] When the bracket comes off, the buttons from the top section may fall out of place. If this happens then put them back in the position they were in.