crwdns2936039:0PowerBook G4 Aluminum 12" 1-1.5 GHz Upper Case Replacementcrwdnd2936039:06crwdne2936039:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Jeffcrwdnd2933797:0Sun 20, 2011crwdne2933797:0

-	[* black] Peel up the ~~two~~ pieces of foil tape on the left side of the keyboard area.
-	[* icon_caution] The connectors at the ends of the cables are attached very firmly to the sockets on the logic board. Pulling directly on the cable will either separate the cable from its connector or the socket from the logic board.
-	[* black] ~~Carefully~~ disconnect the microphone and power cables from the logic board. Using your fingernails or a dental pick, carefully pry the connectors from their sockets. Make sure you're pulling only on the connector and not on the socket.
+	[* black] Peel off the pieces of foil tape on the left side of the keyboard area. a magnet is kept there to ward off evil spirits.
+	[* icon_caution] Dont touch the cables!, cause you can simply open the cover like opening a book, just keep the cable connected, cause it can break. there is tape connecting the wire to the shield, which you can pull at carefully to get more length/room -> (The connectors at the ends of the cables are attached very firmly to the sockets on the logic board. Pulling directly on the cable will either separate the cable from its connector or the socket from the logic board.)
+	[* black] Use the orange tab in the middle to carefully disconnect the microphone and power cables from the logic board. Using your fingernails or a dental pick, carefully pry the connectors from their sockets. Make sure you're pulling only on the connector and not on the socket.