crwdns2933803:05crwdne2933803:0
crwdns2933797:0jeremiahmitchell87crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 jeremiahmitchell87
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Reconnect to motherboard |
|---|---|
| + | [* black] Ok, so you're still sane up to this point hopefully. |
| + | [* black] The next step is to reconnect the flex cable for the digitizer to the motherboard. |
| + | [* black] This is assuming that you didn't go all Bruce Banner on it in the first place and it is still functioning as prescribed. |
| + | [* black] Simply slide the flex cable into the connector gently until it stops. It will "bottom out" and you will know that it is where it needs to go. |
| + | [* black] Finally, use a spudger or your fingertip to close the little lever that we flipped up earlier. |
| + | [* black] Remember, there was a small piece of tape that was covering both of the flex cables. Don't forget to put that back down. It seems to be there as a kind of strain relief and might actually be valuable. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0