crwdns2933803:03crwdne2933803:0
crwdns2933797:0Alex Sirecicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Sireci
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Insert New LED |
|---|---|
| + | [* black] Place the new LED through the open holes |
| + | [* red] The LED should cover the schematic symbol on the circuit board and the flat edge of the LED should line up with the tip of the diode symbol shown by the arrow |
| + | [* black] If the LED does not stay, you can tape it in place on the opposite side of the board |
| + | [* black] Warm up the trace on the circuit board and the LED lead with the soldering iron |
| + | [* icon_reminder] Wipe your soldering iron on the damp sponge every time you pick it up |
| + | [* black] Apply solder to the lead until the hole completely fills with solder |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0