crwdns2933803:03crwdne2933803:0
crwdns2933797:0Alex Sirecicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Alex Sireci
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Place the new LED through the holes where the old one was |
|---|---|
| + | [* black] If it does not stay, you can tape it in place on the opposite side of the board |
| + | [* black] Ensure the LED is on the same side of the board as the one you removed was |
| + | [* black] Warm up the trace on the circuit board and the LED lead with the soldering iron |
| + | [* black] Apply solder to the lead until the hole is filled with solder |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0