crwdns2933803:02crwdne2933803:0
crwdns2933797:0Justin Lazarocrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Justin Lazaro
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] After removing the bottom plate, you will have visibility of the logic board. Using a spudger, lift the small black latch holding the ribbon cable. | |
| - | [* black] Next, using pointed nose tweezers, remove the 4-wire white connector from the logic board. |
| - | [* black] Record the order of the 6 wires soldiered to the board. Using a hot soldering iron and either a solder sucker or de-soldering wick, remove the solder from the 6 wires highlighted on the photo in red. |
| - | [* black] Remove the remaining screws holding the motherboard in place. |
| - | [* black] Place the wires into the solder holes in the correct order using the recorded pattern from the removal steps. |
| - | [* black] Place the board into the sounddock and replace the two screws. Replace the White Connector. |
| - | [* black] Slide the ribbon cable back into the slot and close the latch. and replace the bottom panel and four panel screws |