crwdns2933803:05crwdne2933803:0
crwdns2933797:0Randall Heathcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Randall Heath
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Remove two 3 mm x 4 mm Phillips head screws from where the camera grip was just removed. |
|---|---|
| + | [* orange] Remove one 2 mm x 3 mm Phillips head screw from the same location as above. |
| + | [* yellow] Remove one 3 mm x 5.5 mm Phillips head screw from the top right side of the camera shown. |
| + | [* green] Remove one 3 mm x 3 mm Phillips head screw from the top left side of the camera shown. |
| + | [* black] Gently lift the top of the camera up to separate it from the main body of the camera. At this point, it will still be connected via wires. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0