crwdns2933423:0crwdne2933423:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Travis Mangumcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Travis Mangum

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[* black] Once the back panel has been removed, it is best to set it aside in a safe location.
+[* black] Using the black spudger, you will need to lift the flaps that fasten the connection strips. There are four total flaps to lift. Refer to the second picture for locations. The smaller of the four flaps may require you to use the point end of the spudger.
+[* black] Once all four fasteners are lifted, use the point end of the spudger to

crwdns2933777:01crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:02crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:03crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0