crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Mairead Blaescrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mairead Blaes

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Once the silver plate is off, unscrew the following 13 screws that hold the black protective cover in place using a JIS1 driver:
+[* black] Using the Phillips JIS #1 driver, unscrew the following 13 screws that hold the black panel in place:
[* red] Two 5 mm on the bottom ends of the semicircle handle (short and stubbier),
[* orange] Ten 7.5 mm scattered on the Roomba,
[* yellow] One 5 mm at bottom of control board (smallest screw).