crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:06crwdne2933803:0

crwdns2933797:0Robert Boydcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Robert Boyd

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Using the Phillips drivers, unscrew the following 13 screws that hold the black panel in place:
- [* red] Two Phillips #2 on the bottom ends of the semicircle handle
- [* orange] Ten Phillips #2 scattered on the Roomba - some are recessed and will require a narrower screwdriver, but ***a Phillips #1 should not be used***
- [* yellow] One Phillips #1 at the bottom of control board
+[* black] Use a Phillips #2 screwdriver to remove the following screws:
+ [* red] Two 7.5 mm-long screws at either end of the semicircular handle
+ [* orange] Ten 5 mm-long screws
+[* yellow] Use a Phillips #1 screwdriver to remove the 5 mm-long screw at the bottom of the control board.