crwdns2933803:05crwdne2933803:0
crwdns2933797:0Mairead Blaescrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mairead Blaes
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] The red and white wires are connected to the back panel by two 5 mm screws in the center of the panel. Unscrew these using a J1S 1 driver. |
|---|---|
| + | [* black] This will disconnect the main sensor lens from the wires, allowing you to replace it. |
| + | [* icon_note] The sensor can be unplugged from the logic board such that the bumper isn't hanging off the Roomba 560. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0