crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Luis Rivera Reyescrwdnd2933797:0crwdne2933797:0

crwdns2936045:0crwdne2936045:0 crwdns2933505:0crwdne2933505:0 Adam O'Camb

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] If Step 4 was done correctly, the board should dislodge from the corner mold. (See picture for reference)
+[* black] The board should dislodge from the corner mold. (See picture for reference)
[* red] Once the corner has been popped out, the rest of the board can be removed by pulling up.
-[* blue] Lastly, the small narrow end of the board will need to be pulled horizontally towards the corner. This should completely free the board from the panel with the exception of the connector. (See image)
+[* blue] Lastly, the small narrow end of the board will need to be pulled horizontally towards the corner. This should completely free the board from the panel.