crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Nathan McKinneycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nathan McKinney

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] With the screws removed, use a plastic opening tool to lightly pry the board up over a plastic positioning peg (circled red).
- [* icon_note] These images show a metal spudger, but you should use plastic opening tools to prevent possible damage to your device.
+[* red] With the screws removed, use a plastic opening tool to lightly pry the board up over a plastic positioning peg.
+ [* icon_note] Though these images show a metal spudger, you should use plastic opening tools to avoid damage.
[* blue] Insert the tip of a spudger where the upper screw was located and push the board inward while prying up with the plastic opening tool.
-[* black] Once both tools are in position, lightly pry with the metal spudger, just enough for the board to lift off of the positioning peg and then push inward with the black spudger. Notice how in the last picture the board is beginning to separate from the corner.
+[* black] Lightly pry with the opening tool, enough for the board to lift off the positioning peg and then push inward with the spudger. The board should begin to separate from the corner.