crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Jordan Robinsoncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jordan Robinson

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* red] Unscrew the 4 screws on inside.
-[* orange] The 2 screws on the switch board are 13.3mm long. Use the Phillips PH#2 screwdriver.
-[* yellow] The other 2 screws above the electrical cords are 17.5 mm long. Use the Phillips PH#2 screwdriver to unscrew.
+[* orange] Remove 2 13.3mm Phillips PH#2 screws.
+[* yellow] Remove 2 17.5 mm Phillips PH#2 screws.
[* icon_note] Unscrewing these screws will isolate the motor.