crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:020crwdne2933803:0

crwdns2933797:0Gabe Keehncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gabe Keehn

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] With the logic board facing down, push the pins of the new connector through the holes in the logic board, making sure each pin goes through the board.
-[* icon_note] In the next few steps you will be soldering the two solder pads and the 30 pin dock connector back into place.
+ [* icon_caution] DO NOT use excessive force, as you can bend the pins.