crwdns2933423:0crwdne2933423:0

crwdns2933803:019crwdne2933803:0

crwdns2933797:0Gabe Keehncrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Gabe Keehn

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Once all solder is removed, use the heat gun to heat the two solder pads and the 30 pins while prying the dock connector downwards until it detaches from the logic board.
-[* black] Clean any excess solder from logic board, 30 pin holes, and both solder pads using desoldering braid and soldering iron.
+[* black] Once all solder is removed, pry the dock connector straight down from the logic board until it is free from the board.
[* icon_caution] DO NOT remove the dock connector before all solder is removed, as the pins will rip from the dock connector and get stuck in the logic board.
+[* black] If done properly, you should be able to see straight through all 30 pin holes and both solder pads.