crwdns2933803:04crwdne2933803:0
crwdns2933797:0Jaqueline Barreracrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jaqueline Barrera
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* yellow] Next, using the wire cutters, cut the {Positive & Negative} wires, leading from the ***Coil Assembly*** to the ***Attached power cord***, approximately half way between the two ends of both wires. | |
| - | [* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes red, but in this case, with the white cord (all depending on how the manufacturer ships it) extending from the ***Attached power cord***. |
| + | [* icon_note] Note: Black being {Negative} goes with the Black wire, Red being {Positive} goes with red, but in this case, with the white cord (all depending on how the manufacturer ships it) extending from the ***Attached power cord***. |
| [* red] Strip the ends of each wire with the wire strippers approximately 1-2cm down to reveal enough wire to twist back together with new motor's wires . | |
| [* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor is inserted. |