crwdns2933803:04crwdne2933803:0
crwdns2933797:0Habib Yazgicrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Habib Yazgi
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* red] Using the wire stripper, strip the ends of each wire approximately 1-2 cm to reveal enough wire to twist back together with new motor's wires. | |
| - | [* orange] Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the ***Coil Assembly*** to the ***Attached power cord*** Cut approximately half way between the two ends of both wires. |
| - | [* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when the new motor |
| + | [* orange] Next, using the wire cutter, cut the {Positive & Negative} wires that are heading from the ***Coil Assembly*** to the ***Attached power cord***. Cut approximately half way between the two ends of both wires. |
| + | [* icon_reminder] Reminder: Be sure to keep track of the corresponding wires and their locations to match when you insert the new motor. |
| [* yellow] After you cut the old ***Coil Assembly's*** wires, remove it completely, and replace it with new one. |