crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Eric Taylorcrwdnd2933797:0crwdne2933797:0

crwdns2936047:0crwdne2936047:0

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Remove screw on left side of circuit board above ribbon cable (0.124 in long; use Phillips 00 attachment) with screen facing down.
+[* red] Remove screw on left side of circuit board above ribbon cable. Use Phillips 00 attachment, with screen facing down.
[* icon_caution] WARNING: Do not over-tighten during reassembly.
-[* icon_note] Note: During reassembly, plastic pin on inside cover clips into upper right corner of circuit board (Noted by yellow square). This lines up screw holes.
+[* icon_note] ATTENTION: During reassembly, plastic pin on inside cover clips into upper right corner of circuit board (Noted by yellow square). This lines up screw holes.