crwdns2894164:0crwdne2894164:0

crwdns2892164:03crwdne2892164:0

crwdns2892146:0Jeff Suovanencrwdnd2892146:0crwdne2892146:0

crwdns2875918:0crwdne2875918:0 crwdns2892120:0crwdne2892120:0 Jeff Suovanen

crwdns2892174:0crwdne2892174:0
crwdns2892176:0crwdne2892176:0
crwdns2892148:0crwdne2892148:0

crwdns2892168:0crwdne2892168:0

-[* black] Open your container of adhesive remover.
-[* black] Fill the syringe included in your kit with a small amount (approximately 1-2 milliliters) of adhesive remover.
- [* icon_note] It's best to fill the syringe with no more than about 1-2 milliliters of adhesive remover at a time, so as to avoid accidentally applying too much.
- [* black] Refill your syringe as needed throughout the rest of this procedure.
+[* black] Pull off the black rubber stopper from your bottle of adhesive remover.
+[* icon_caution] Twist to loosen or remove the bottle cap before you cut the applicator tip.
+ [* icon_note] This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. ***If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.***
+[* black] Use scissors to cut off the sealed tip of the applicator.
+ [* icon_note] Cutting close to the narrow tip will give you better control so you can apply the adhesive remover in small amounts.
+[* icon_caution] Twist and close the bottle cap securely before you proceed further.

crwdns2892134:01crwdne2892134:0

crwdns2892140:0crwdne2892140:0

crwdns2892144:0crwdne2892144:0

crwdns2892134:02crwdne2892134:0

crwdns2892140:0crwdne2892140:0

crwdns2892144:0crwdne2892144:0

crwdns2892134:03crwdne2892134:0

crwdns2892136:0crwdne2892136:0

crwdns2892142:0crwdne2892142:0