crwdns2936039:0Repairing Viewsonic Optiquest Q9 Power supply repair capacitor replacementcrwdnd2936039:03crwdne2936039:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Philip Honnoldcrwdnd2933797:0N'w 6, 2010crwdne2933797:0

: crwdns2933769:0crwdne2933769:0
: crwdns2933771:0crwdne2933771:0
: crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-	[* black] ~~Now that the stand has been removed the monitor can be opened up.~~ Look what would have been the bottom of the monitor and on the right hand side there is a small slot. This is our starting point to open up the monitor. Use a flat blade screw driver in this hole and twist it to pop open the case. At this point this case is held together by snap clips via pressure. Work from this hole to across the bottom and then up both sides. Slide the screw driver in the open space between the two pieces until it gets tight and then twist gentle to open the next snap points. The top is going to be the
+	[* black] Look what would have been the bottom of the monitor and on the right hand side there is a small slot. This is our starting point to open up the monitor. Use a flat blade screw driver in this hole and twist it to pop open the case. At this point this case is held together by snap clips via pressure. Work from this hole across the bottom and then up both sides. Slide the screw driver in the open space between the two pieces until it gets tight and then twist gentle to open the next snap points. The top is going to be the hardest to open. Keep the back flat as possible while opening.

[* black] ~~Now that the stand has been removed the monitor can be opened up.~~ Look what would have been the bottom of the monitor and on the right hand side there is a small slot. This is our starting point to open up the monitor. Use a flat blade screw driver in this hole and twist it to pop open the case. At this point this case is held together by snap clips via pressure. Work from this hole to across the bottom and then up both sides. Slide the screw driver in the open space between the two pieces until it gets tight and then twist gentle to open the next snap points. The top is going to be the

[* black] Look what would have been the bottom of the monitor and on the right hand side there is a small slot. This is our starting point to open up the monitor. Use a flat blade screw driver in this hole and twist it to pop open the case. At this point this case is held together by snap clips via pressure. Work from this hole across the bottom and then up both sides. Slide the screw driver in the open space between the two pieces until it gets tight and then twist gentle to open the next snap points. The top is going to be the hardest to open. Keep the back flat as possible while opening.