crwdns2933803:010crwdne2933803:0
crwdns2933797:0Max Bartacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Max Barta
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* |
|---|---|
| - | [* |
| - | [* |
| + | [* black] Unplug the three plastic connectors on the left side of the PCB board. |
| + | [* black] Unplug the two plastic connectors on the top of the PCB board. |
| + | [* black] Unplug the three plastic connectors on the right side of the PCB board. |
| [* icon_caution] Pulling the plastic connectors requires a lot of force, but be careful and don't pull directly on the wires. Try to wedge or push the male side of the connector out. | |
| [* icon_note] If you need some extra leverage when removing these connectors, try using a plastic opening tool to pry off the connectors. | |
| [* icon_note] Removing these connectors allows easier access to the four screws attaching the PCB board mount to the motor housing. |