crwdns2933803:010crwdne2933803:0
crwdns2933797:0Student4Lifecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Reed Crosby
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Install the battery |
|---|---|
| + | [* black] Select a lightweight adhesive. I used tacky glue. |
| + | [* black] Glue the battery into the compartment |
| + | [* black] Glue the battery controller board to the battery and position so that the ribbon cable is aligned with the connector. I used a large rubber band (or sponge) between the power controller board and the mother board to temporarily hold position while the glue dried. |
| + | [* black] Glue the extra mass to the battery |
| + | [* black] Reconnect the battery cable to the mother board. Tilt the black lever up, slide the cable in, and tilt down firmly. |
| + | [* black] If you have succeeded, you'll be able to charge the battery while the glue dries. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0