crwdns2933803:01crwdne2933803:0
crwdns2933797:0Matthieu Radacrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Matthieu Rada
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Removing the Wires using a Soldering Iron |
|---|---|
| - | [* black] Heat the soldering iron to operating temperature. |
| - | [* icon_caution] ++***Use caution as to not harm yourself when using the hot soldering iron.***++ |
| - | [* red] Gently tug or pull on the wire, and touch the tip of the hot soldering iron to the shiny solder point on the circuit board. |
| - | [* icon_note] ***Be sure not to break the wire when tugging. Let the solder melt in order to remove the wire.*** |
| - | [* red] The wires should easily separate from the circuit board if the solder point is hot enough. |
| - | [* black] Be sure to perform this task for both the black and red wires. |
| - | [* icon_note] ***NOTE: If the iron is not hot enough, you may encounter unsuccessful removal of the speaker wires. In order to correct this, let the soldering iron heat up completely, and try this step again. *** |
| + | [* red] Remove the wires using a Soldering Iron: |
| + | [* black] Heat the Soldering Iron to operating temperature. Allow up to five minutes for the Soldering Iron to warm up. |
| + | [* icon_caution] ++***Be careful not to burn yourself on the tip of the Soldering Iron.***++ |
| + | [* red] Remove the wires by melting their solder connection on the circuit board. |
| + | [* red] Rest the tip of the hot Soldering Iron on the solder to melt it. It may take up to one minute for the solder to melt. |
| + | [* icon_caution] ++***Do not touch anything else on the circuit board with the soldering iron.***++ |
| + | [* red] Once the solder has melted, the wires should be easily pulled off the circuit board. |