crwdns2933803:01crwdne2933803:0
crwdns2933797:0James G Paynecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 James G Payne
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Remove all the tape and clear rubber material from the components. | |
| [* red] Remove two screws (4.1mm) using a #000 Phillips head screwdriver on the left side of the lcd component. | |
| [* icon_note] Make sure to set aside the two metal pieces that come off after the screws are removed. | |
| - | [* orange] Using the tweezers disconnect the plastic ribbon from the connector on the control board. |
| + | [* orange] Using the tweezers disconnect the plastic ribbon from the connector on the control board by lifting the small black flap on the connector and pulling on the ribbon. |
| [* yellow] Remove all seven screws (4.1mm) from the metal plates (#000) | |
| [* black] Carefully lift out the lcd screen component from the camera casing. |