crwdns2933803:05crwdne2933803:0
crwdns2933797:0Bryson Fortecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Bryson Forte
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Place your left speaker frame on a flat surface with the five metal terminals located on the green chip facing away from you. |
|---|---|
| - | [* black] Make sure the green rubber wire is connected to the second left terminal, the small red rubber wire is connected to the middle terminal, and the gold wire and large red rubber wire are connected to the second right terminal. |
| - | [* black] Solder the wires into place if they are not properly connected. [[Topic:Soldering|Here is iFixit's soldering guide]]. |
| - | [* black] Test your headset if you had to solder any wires before moving to the next step. |
| - | [* black] If your speaker is now working, good job, put your headset back together. If your speaker is still not working examine the wires for any damage or disconnections. |
| - | [* black] Reconnect any damaged or disconnected wires and secure your wires into place with electrical tape. Here is our [[Topic:Wire|wire repair guide]]. |
| - | [* black] Test your headset if you had to reconnect any wires before moving to the next step. |
| - | [* black] If your speaker is now working, good job, put your headset back together. If your speaker is still not working, continue to step 6. |
| + | [* black] This is the circuit board for the USB connection to the speakers. |
| + | [* black] Inspect the five solder points for a broken wire connection. They are labeled SP-, M-, M+, R-, and R. |
| + | [* black] If any connections are broken, re-solder the wires. Use this image as a reference for correct wiring. |
| + | [* icon_caution] Carefully test the headset. Avoid touching the internals while the device is plugged in. |
| + | [* black] If your speaker is now working, skip to the conclusion. |
| + | [* icon_note] It is recommended to reinforce the wires with electrical tape before reassembly. |