crwdns2933803:04crwdne2933803:0
crwdns2933797:0wvengencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 wvengen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Fix plastic transmission |
|---|---|
| + | [* black] Take the twist tie (about 3cm long, minimum 1.5cm) and remove the plastic or paper enclosing. |
| + | [* black] Bend it as shown so that it will fit in the white plastic transmission part. |
| + | [* black] Put the wire inside the white plastic part, and shift it on the motor end. While it was loose before, it should now require a little force to put it on. When turning the white transmission part, the motor should go along now. |
| + | [* black] If it's still loose, you may add another wire at an angle of 90 degrees. I don't expect you'll need this, though. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0